+ Post New Thread
Page 1 of 2 1 2 LastLast
Threads 1 to 20 of 25

Forum: Electrical

What wire goes where?

  1. Sticky Thread Sticky: 1998 Harness Mod

    Circuit Number C1 (Red) This is going to take a while to put together. If anyone has the 99+ instructions and wants to post please do. This...

    Started by thomas.creation‎, 07-02-2012 05:38 PM
    • Replies: 3
    • Views: 5,730
    07-02-2012, 06:41 PM Go to last post
  1. Accelerator pedal assembly

    Who has installed a gm dbw accelerator pedal assembly? Looking for ideas

    Started by Oja‎, 01-16-2018 08:11 PM
    • Replies: 2
    • Views: 1,473
    03-14-2018, 05:28 AM Go to last post
  2. 06+ DBW Inquire

    I apologize in advance if this has been addressed before, but I searched and could not find any answers. For those with with 06+ dbw s2000's, how...

    Started by toohai4yah‎, 03-09-2016 04:59 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 4,784
    12-21-2017, 10:21 AM Go to last post
  3. Factory dash /plug n play/ (semi) aem infinity 8h

    Whats your guys thoughts on getting an aem infinity 8 and ls6 aem engine wiring harness and then scienceofspeeds CAN translator for factory dash. Or...

    Started by Oja‎, 12-16-2017 12:03 PM
    • Replies: 1
    • Views: 623
    12-16-2017, 12:27 PM Go to last post
  4. Available vendors for LS to S2000 Harnesses?

    So I'm starting to make some good progress on my 5.3 Turbo LS swap into my AP1 street/drag car. (Solid 9" 4 link, cell, 28" slicks, 4.5" skinnies,...

    Started by Prokaw875‎, 07-21-2016 08:35 AM
    • Replies: 3
    • Views: 4,902
    10-28-2016, 09:03 PM Go to last post
  5. Cruise Control

    So first thread I made about this mysteriously disappeared? Does anybody have functioning cruise control with one of these swaps? I assumed it...

    Started by jonathan_ed3‎, 09-23-2016 04:49 PM
    • Replies: 7
    • Views: 3,197
    10-02-2016, 11:01 AM Go to last post
  6. Speedo + Eps not working

    I've got my car idling! Goes to the tuner on Tuesday to put a good map on it. Running an omex 710 series Ecu along side the honda, no Gm Ecu. I...

    Started by Carl Bourbon‎, 07-27-2014 12:37 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 6,296
    06-16-2016, 07:34 PM Go to last post
  7. Power Steering

    I can not get my power steering to work. I do not have the Honda ECU only the GM ECU. Somehow after going to the shop my power steering started to...

    Started by 1999s2k‎, 06-06-2013 01:36 AM
    • Replies: 7
    • Views: 5,057
    06-03-2016, 09:00 PM Go to last post
  8. Does the SGI 5e's support of 16x ppm multiplication make gm or viper sensors a possib

    I noticed the SGI 5c speed sensor multiplier is no longer being produced and has been replaced by a new model. The previous model was able to...

    Started by imTehk‎, 04-29-2016 11:59 PM
    • Replies: 2
    • Views: 3,046
    05-04-2016, 09:34 PM Go to last post
  9. Wiring advice

    I bought the Import Muscle guide and I am still confused on the wiring. Part of this is due to having a standalone harness for my ls3. Id have a...

    Started by imTehk‎, 04-29-2016 08:16 PM
    • Replies: 0
    • Views: 2,651
    04-29-2016, 08:16 PM Go to last post
  10. PCM Location? Where Is Your Mounted? Advice

    alright guys, i'm in bed of help, who here has mounted there pcm inside the cabin on the driver side? if so, where and how did you do it? wiring is...

    Started by dean_c89‎, 09-09-2014 03:54 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 6,459
    04-11-2016, 05:34 PM Go to last post
  11. t56 reverse lockout solenoid

    on a 99-02 PCM, is it possible to enable the reverse lockout solenoid functionality via the PCM? The GM PCM uses the clutch position switch which...

    Started by jonathan_ed3‎, 11-10-2015 07:33 PM
    • Replies: 1
    • Views: 3,372
    11-10-2015, 09:13 PM Go to last post
  12. Tach not working

    I've got an issue where my Tach is not reading. I've got the single wire hooked up fine. I have all truck engine/harness/ecu and I'm wondering if...

    Started by recliner15‎, 11-07-2015 06:38 AM
    • Replies: 1
    • Views: 2,970
    11-09-2015, 07:55 PM Go to last post
  13. Dakota Digital SGI-5 issue

    I installed the IM speed sensor kit with the Tweak'd Performance harness and had an issue that stumped me for a couple weeks that I wanted to pass...

    Started by Drstrangelove‎, 07-04-2015 10:17 AM
    • Replies: 4
    • Views: 3,865
    08-07-2015, 01:23 PM Go to last post
  14. Wiring Theory

    I have my gauges (AFR/Oil Pressure/Water Temp/Shift Light/Ethanol Content) wired to a 600v/15amp bus/panel; single 12v connection to the drivers side...

    Started by herecomesboost‎, 02-19-2014 08:10 PM
    4 Pages
    1 2 3 ... 4
    • Replies: 30
    • Views: 13,917
    07-09-2015, 08:37 PM Go to last post
  15. Merging GM and Honda evap systems?

    Has any one successfully used the GM PCM to control the honda evap system? I will figure it out, but I would love to hear from others about their...

    Started by Keith P‎, 05-05-2014 01:42 AM
    • Replies: 4
    • Views: 4,424
    06-30-2015, 10:07 PM Go to last post
  16. HELP how to wire the ls harness to S2K harness

    I need some real help on doing the wiring on the LS1 swap,, i have a motor from a 99 SS camaro, i have the full harness and ecu,, but i don't know...

    Started by NFR01‎, 10-28-2013 09:16 PM
    • Replies: 7
    • Views: 5,913
    04-17-2015, 12:38 PM Go to last post
  17. Gauging Interest - AEM Infinity harness - dbw

    I know most of you guys run an oem GM ecu, but we have done a few ls swapped cars with AEM infintiy and retained the DBW throttle, I wanted to gauge...

    Started by Wadzii‎, 01-28-2015 05:52 PM
    • Replies: 5
    • Views: 4,280
    04-09-2015, 03:12 AM Go to last post
  18. Which ECU to use?

    Hey, I'm going to be running HPTuners to run nitrous and tune. Which ECU do I need to run? Does it really matter which ECU I use if I'm going to...

    Started by ryguy2588‎, 11-03-2014 11:30 PM
    • Replies: 2
    • Views: 3,619
    11-13-2014, 10:36 PM Go to last post
  19. 5.3 swap questions

    I purchased a 5.3 aluminum block for my swap instead of an LS1 It came with the wiring harness and ECU Does anyone know what the differences are...

    Started by recliner15‎, 09-15-2014 10:17 AM
    • Replies: 5
    • Views: 4,174
    10-21-2014, 07:29 PM Go to last post
  20. Speed sensor

    I'm not sure if any of you follow us on our Facebook page and have seen this already. This might come in handy for some of your builds out there....

    Started by xyster‎, 04-25-2014 06:47 AM
    • Replies: 8
    • Views: 4,839
    04-29-2014, 09:23 PM Go to last post

+ Post New Thread

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts